Most popular engines have a 37.8mm distance between mounting holes.
However some engines (for example, Picco) have a smaller distance
(37mm). If your engine has the smaller distance between mounting
holes, you need to enlarge the mounting holes (for example, make each
hole ø0.2~0.4mm larger) to allow the engine to t the engine mounts
properly.
ENLARGE ø0.2~0.4mm
ENLARGE ø0.2~0.4mm
<37.8mm
37.8mm
THREAD LOCK
all screws
THREAD LOCK
all screws
THREAD LOCK
(screw not included)
THREAD LOCK
➊
➋
Attach manifold to engine
using appropriate springs
911410
SHF M4x10
908312
SCH M3x12
902306
SH M3x6
8. ENGINE & CLUTCH
Adjust gear mesh so there is minimal
play between the gears.
Too tight gear mesh will put excessive
strain on all parts and damage the
parts. Too loose gear mesh may result
in stripped gears.
To Next Page
Loading...
