Xray X12 - Ride Height Adjustment; Track-Width

20
To increase rear track width, add
shims as shown.
BEARING OIL
(HUDY #106230)
(HUDY #106230)
FLANGED
FLANGED
INITIAL SETTING
1mm
1mm
OIL
OIL
To set track-width, use the hole in the POD lower plate as the
centre point; this hole should always be centred between the two
rear wheels once overall track-width is set. To set the track-width
more easily, set the car on a ruler or use a digital vernier caliper.
Rear track-width is directly affected by wheel offsets, which can
vary depending on tire brand.
DETAIL
LEFT = RIGHT
NOTE ORIENTATION
DETAIL
0
1.0
-1.0
1.25
-1.25
0.5
-0.5
0.75
-0.75
0.25
-0.25
3. SOLID AXLE
951438
BB 1/4“x3/8“x1/8“
375090
6.4x8.4x1.0
375090
6.4x8.4x0.5
902205
SH M2x5
902205
SH M2x5
902305
SH M3x5
SPUR GEARS 64P
#375872 72T OPTION
#375872 72T OPTION
#375872 72T OPTION
#375875 75T OPTION
#375875 75T OPTION
#375875 75T OPTION
#375876 76T INCLUDED
#375876 76T INCLUDED
#375876 76T INCLUDED
#375878 78T OPTION
#375878 78T OPTION
#375878 78T OPTION
#375880 80T INCLUDED
#375880 80T INCLUDED
#375880 80T INCLUDED
#375884 84T OPTION
#375884 84T OPTION
#375884 84T OPTION
#375888 88T OPTION
#375888 88T OPTION
#375888 88T OPTION
#375892 92T OPTION
#375892 92T OPTION
#375892 92T OPTION
These eccentric bushings adjust the
RIDE HEIGHT
of the rear pod. Make sure to use the SAME eccentric bushings on BOTH sides.
IMPORTANT! DO NOT overtight this screw.
IMPORTANT!
DO NOT overtight this screw.
3x5mm
3x5mm
3x5mm
3x5mm
3x5mm
3x5mm