27
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun while
system is pressurized.
• Always be certain spray gun, nozzles and accessories are correctly
attached.
starting your electric washer
11. To start the machine, locate the ON/OFF switch on the side of the
motor, and switch it to the ON position. (see component chart to
locate switch)
7. Similarly, attach other end of high pressure hose to high pressure
outlet (A) on pump. Pull down on collar of quick connect, slide onto
pump and let go of collar. Pull on hose to be sure of tight connection.
8. Turn Water Supply on, point gun in a safe direction and squeeze the
trigger to purge the pump of air and debris. Do this for at least 30
seconds.
9. Take a look at all connections to make sure there are no leaks or loose
connections.
IMPORTANT: DO NOT siphon standing water for the water supply. Use
ONLY cold water (less than 100°F/38°C).
10. Connect the garden hose to the water inlet. Tighten by hand.
A
A
B
B
axial pump triplex pump
To Next Page
Loading...
Need help?
General