14
FB350 Folding Bike
FUNCTIONS AND OPERATIONS
1. SCAN: Press MODE button until “▼” appears at SCAN position, monitor will rotate through
the following functions: speed, distance, time, calorie, ODO, and pulse, each display will be
hold 4 seconds.
2. TIME: Shows your elapsed workout time up to 99:59. Counts down from your preset target
time to 0:00 during your workout.
3. SPEED: Display current speed. The maximum value is 999.9 M/H
4. DISTANCE: Count the distance from exercise start to end. The maximum value is 99.99
MILE.
5. CALORIE: Count the total calories from exercise start to end. The maximum value is 999.
6. ODOMETER: Monitor will display the total accumulated distance. The maximum value is
99.99 MILE.
7. PULSE RATE: Press MODE button until “▼” appears at PULSE position.
Before measuring your pulse rate, please place your palms of your hands on both of your
contact pads and the monitor will show your current heart beat rate in beats per minute(BPM)
on the LCD after 6~7 seconds.
Remark: During the process of pulse measurement, because of the contact jamming, the
measurement value may be higher than the virtual pulse rate during the rst 2~3 seconds,
then will return to normal level. The measurement value cannot be regarded as the basis of
medical treatment.
NOTE
1. If the display is faint or shows no gures, please replace the batteries.
2. The monitor will automatically shut off if there is no signal received after 4 minutes.
3. The monitor will be auto-powered on when starting to exercise push button w/signal in.
4. The monitor will automatically start calculating when you start to exercise and will stop cal-
culating when you stop exercising for 4 seconds
To Next Page
Loading...
Need help?
General
