7
Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net
❑ Push the battery holder into the battery box, along with the wire and plugs.
❑ Reinstall the battery box cover, making sure that you don't pinch the wire.
❑ Slide the receiver antenna into one end of the plastic antenna tube and out the
other end.
✦✦
✦✦
✦IMPORTANT
✦✦
✦✦
✦ To make it easier to slide the antenna through the tube, first make
sure there are no kinks or bends in the antenna wire, then wet the antenna wire with
glass cleaner. The glass cleaner will make the antenna slide easily through the tube.
❑ Push the end of the antenna tube firmly into the molded hole in the top of the receiver
box cover.
✦✦
✦✦
✦IMPORTANT
✦✦
✦✦
✦ Leave the excess antenna hanging from the top of the tube. Under
no circumstances should you cut or shorten the antenna.
❑ Slide the transmitter's on/off switch to turn on the transmitter. The green LED should
glow brightly.
✦✦
✦✦
✦IMPORTANT
✦✦
✦✦
✦ If the green LED does not glow or if the red LED is glowing, check the
batteries and replace them if necessary.
❑ Slide the receiver's on/off switch to turn the receiver on. You should hear the servos
move to their proper positions.
✦✦
✦✦
✦IMPORTANT
✦✦
✦✦
✦ Always turn on the transmitter first, followed by the receiver. After
you're done, turn off the receiver first, then turn off the transmitter. This will prevent the
possibility of a runaway vehicle or damage to the servos.
To Next Page
Loading...
