EasyManuals Logo

Xtool P2 User Manual

Xtool P2
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
10
6. Install the smoke exhaust pipe
If you have purchased a smoke purifier, follow
the instructions to connect it to xTool P2.
Use xTool P2
1. Download and install xTool Creative Space (XCS)

Table of Contents

Other manuals for Xtool P2

Preview: Instructions
Instructions10 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xtool P2 and is the answer not in the manual?

Xtool P2 Specifications

General IconGeneral
Laser TypeDiode Laser
Laser Power55W
Maximum Engraving Speed600mm/s
CameraYes
ConnectivityUSB, Wi-Fi
SoftwareXCS (xTool Creative Space)
Supported File FormatsSVG, DXF, JPG, PNG, BMP
Supported MaterialsWood, Acrylic, Fabric, Leather, Paper, Rubber
Safety FeaturesEmergency Stop
Focus AdjustmentAutofocus
Power SupplyAC 110-240V, 50/60Hz