Need help?Do you have a question about the Xtool P2 and is the answer not in the manual?
General| Laser Type | Diode Laser |
|---|---|
| Laser Power | 55W |
| Maximum Engraving Speed | 600mm/s |
| Camera | Yes |
| Connectivity | USB, Wi-Fi |
| Software | XCS (xTool Creative Space) |
| Supported File Formats | SVG, DXF, JPG, PNG, BMP |
| Supported Materials | Wood, Acrylic, Fabric, Leather, Paper, Rubber |
| Safety Features | Emergency Stop |
| Focus Adjustment | Autofocus |
| Power Supply | AC 110-240V, 50/60Hz |
Steps for opening the lid, removing items, and unscrewing the baseplate.
Tighten the screw that fixes the baseplate after removal.
Overview and labeling of the machine's main components.
Identification of further components including cameras, ports, and baseplate.
Inspect the machine casing for any damage before use.
Remove lid sticker and reset the emergency stop switch.
Manually move the laser module to ensure proper movement.
Check the laser tube for cracks or damage.
Instructions on filling the water tank with antifreeze and purified water.
Connect the machine to power, turn it on, and fit the rear cover.
Guidance on installing the smoke exhaust pipe.
Download and install the xTool Creative Space (XCS) software.
Connect the xTool P2 to your computer and the XCS software.
To Next Page
