Xtool P2 User Manual

6
2. Remove the sticker used to prevent the lid from locking and turn the emergency stop
switch to reset it.
3. Manually move the laser module to check whether it can move properly. If it can't, do
not use the machine and contact xTool after-sales services.
4. Check the laser tube. If it is cracked or damaged, do not use the machine and contact
xTool after-sales services.
(1) Unscrew the screws that fix the rear cover and remove it

Xtool P2 Specifications

General

Laser Type	Diode Laser
Laser Power	55W
Maximum Engraving Speed	600mm/s
Camera	Yes
Connectivity	USB, Wi-Fi
Software	XCS (xTool Creative Space)
Supported File Formats	SVG, DXF, JPG, PNG, BMP
Supported Materials	Wood, Acrylic, Fabric, Leather, Paper, Rubber
Safety Features	Emergency Stop
Focus Adjustment	Autofocus
Power Supply	AC 110-240V, 50/60Hz