Xtrem Bots JAMES THE SPY BOT - Page 12

12
3. BATTERIES INSTALLATION
IN THE TRANSMITTER
IN THE ROBOT
Robot batteries is into the back of the James the spybot.
To change the batteries, remove the battery cover using a Phillips
screwdriver. Insert 3 x 1.5V “AA”/LR6 batteries (not included). Close the
battery cover using a Phillips screwdriver.
Switch OFF the robot before change the batteries.
4. START JAMES THE SPYBOT
Switch on the ON/OFF button on the chest of James.
1. Use a philips’ head screw to open the battery compartment lid of controller.
2. Put 2 x 1.5V “AA” batteries inside the battery compartment.
3. Put the lid back and use a screw to tighten the lid.