14
7. DEMO MODE
6. STANDBY BUTTON
8. PROGRAMMING
Press the “Demo Mode” button on the transmitter. James the
spybot will begin a demonstration of its skills with a mix of
dance, sounds and movements.
The “StandBy” button starts James the spybot.
By pressing the button James the spybot goes on StandBy Mode
and stays sleep until this button would be pressed again.
After 2 and a half minutes of inactivity, the robot enters standby
mode automatically. Before the robot go into StandBy mode, it will
emit some sounds in advice.
1. Press the “Program” button until hear a `beep’ sound.
2. Up to 50 actions can be programmed. You can slide forward,
slide back, walk forward, walk backward, turn left, turn right or
make preset sounds.
3. Press “Program” button to perform programmed functions
again.
4. When it is not in use atomatically exit.
9. MUSIC
Press the “Music” button on the transmitter.
James the spybot will perform a dance. Press up
to 3 times to change the music played.
To Next Page
Loading...
