4
WATERPROOF CASE
Before sealing the waterproof case, keep the camera housing’s rubber seal clean, a single hair or grain of sand can cause
a leak. You can test by closing the case without inserng the camera. Submerse the case completely in water for about a
minute. Remove the case from the water, dry off its exterior with a towel, and then open the case. If the interior is dry,
the case is safe for use under water.
Aer use in salt water you will need to rinse the outside of the housing with fresh water and then dry. This will prevent
corrosion of the hinge pin and salt buildup in the seal, which can cause failure.
To clean the seal, rinse in fresh water and shake dry (drying with a cloth may cause lint to compromise the seal).
Re-install the seal into the grooves in the backdoor of the housing.
SECURITY INFORMATION
This device was designed and built to guarantee your safety. The safety mechanisms implemented in the product will
protect you if you observe the following installaon, operaon and troubleshoong procedures:
Please carefully read and follow the following instrucons before handling and installing your device,
Keep these instrucons for further reference.
GENERAL
Don't shake, or it may lead to damage to the product.
Only use components and accessories (power supply...) recommended by the manufacturer,
The illustraons of the product may vary from actual product.
To Next Page
Loading...