INSTALLATION
STEP 1: Adjust the height of the machine foot to keep
the machine balanced.
STEP 2: Connect three connectors between the
support tube and the controller, then place the
support tube toward the rear of the machine vertically.
Then tighten the tube with 4 of the M8x12 screws.
STEP 3: Place the two lower safety handles to the
machine body and tighten them with 4 of the M6 x
12 screws.
STEP 4: Connect the two upper safety handles
then tighten them with 4 of the M5 x 12 screws.
Then tighten the two upper safety handles to the
top support tube with two of the M8 x 50 screws.
STEP 4: Connect three connectors between
the console and the support tube, then tighten
the console with three of the M6 x 12 screws.
NOTE: Wires should not be pressed by console
after assembly.
5
To Next Page
Loading...
