Xtreme J60 User Manual (English)

Questions and Answers:

C
Cassie CruzJul 27, 2025
Why is the Xtreme Power Supply backup time shorter than expected?
- T
  Timothy VargasJul 27, 2025
  If the backup time of your Xtreme Power Supply is shorter than expected when the power fails, it could be due to several reasons. The UPS might be overloaded, in which case you should remove some of the load from its output. Alternatively, the battery voltage may be too low; try charging the UPS for at least 8 hours. Finally, the battery itself could be defective and need replacement with the same type of battery.
M
Morgan LewisAug 3, 2025
What to do if the Xtreme J60 Power Supply alarm continuously sounds when AC input is normal?
- S
  Susan RamseyAug 3, 2025
  If the alarm on your Xtreme Power Supply is continuously sounding even when the AC input is normal, there are a couple of potential causes. First, the UPS might be overloaded, so try removing some of the load from its output. If the problem persists, it could indicate a UPS fault, requiring the unit to be returned for service.
G
Gabrielle HallAug 8, 2025
How to fix no LED display on the Xtreme Power Supply front panel?
- A
  Amy HuertaAug 9, 2025
  If there is no LED display on the front panel of your Xtreme Power Supply, several factors could be responsible. The battery might be low, so charge the UPS for at least 8 hours. There could be a battery fault, meaning you should replace the battery with the same type. Also, ensure the UPS is turned on by pressing the Power Switch on the front.
J
Jonathan RochaAug 14, 2025
Why does the Xtreme J60 Power Supply alarm sound every 2 seconds when AC input is normal?
- J
  James AlvaradoAug 14, 2025
  If your Xtreme Power Supply alarm sounds every 2 seconds while the AC input is normal, it could be due to a battery defect, in which case you should replace the battery with the same type. Another possibility is that the charging circuit is damaged, requiring the unit to be returned for service.
C
Charles ParkerAug 20, 2025
What does it mean if the blue LED is flashing on my Xtreme J60 Power Supply?
- J
  James MyersAug 20, 2025
  If the AC input to your Xtreme Power Supply is normal but the blue LED is flashing, it suggests that the power cord is loose. Reconnect the input power cord properly to resolve this issue.

Xtreme J60 Specifications

General

Maximum Power	600W
Fan Size	120mm
Input Voltage	100-240V
Input Frequency	50-60Hz
Form Factor	ATX
Modular	Non-Modular
Output	+12V@45A, -12V@0.3A, +5VSB@2.5A
Connectors	3 x Molex
Protections	OVP, OPP, SCP
Dimensions	150mm x 140mm x 86mm
Model	J60