Xtreme J60 - Indicators & Alarm Conditions; Important Safety Instructions

Xtreme Power Conversion Corporaon
J60 User’s Manual
Page 4
Uninterrupble Power Supply
Power switch on the back of the UPS. For best results, the baeries in the UPS should be charged for at least 8
hours before use. The UPS charges its baery while it is connected to AC ulity power and powered on.
Connecng the Loads
Plug the loads to be supported by the UPS into the output receptacles on the front of the UPS. Simply turn the
power switch on the UPS on and the devices connected to the UPS will be protected by the UPS unit.
Turn UPS ON / OFF
To turn the UPS unit on, press the power buon on the UPS and hold for three seconds. To turn the UPS unit o,
press the power buon and hold for one second.
Connecng Local Monitoring Soware (oponal)
If it is desired to use the Local Monitoring Soware, and if your UPS is equipped with USB communicaons, con-
nect a USB cable from your computer to the UPS, and install the soware from the CD.
Indicators & Alarm Condions
Condion Visual Indicator Alarm
AC mode LED illuminated No Audible Alarm
Baery mode LED ashes every 10 seconds Audible Alarm sounds every 10
seconds
Low baery mode LED ashes every 1 second Audible Alarm sounds every 1
second
Fault LED is illuminated Audible Alarm is connuous
Alarm for over temperature protec-
on
LED ashes every 0.5 seconds No Audible Alarm
Important Safety Instrucons: (Save These Instrucons)
CAUTION! (UPS having Internal Baeries): Risk of electrical shock – Hazardous live parts inside this unit are ener-
gized from the baery supply even when the input AC power is disconnected.
CAUTION! (No User serviceable Parts): Risk of electrical shock, do not remove cover. No user serviceable parts
inside. Refer servicing to qualied service personnel.
CAUTION! (Non-isolated Baery supply): Risk of electric shock, baery circuit is not isolated from AC input, haz-
ardous voltage may exist between baery terminals and ground. Test before touching.
WARNING! Unit intended for installaon in a controlled environment.
CAUTION! Do not dispose of baeries in a re, the baery may explode.
CAUTION! Do not open or mulate the baery, released electrolyte is harmful to the skin and eyes.
CAUTION! A baery can present a risk of electric shock and high short circuit current. The following precauon
should be observed when working on baeries:
• Remove watches, rings or other metal objects.
• Use tools with insulated handles.