Xtrons CM101HD - Troubleshooting Guide; Common Issues and Solutions; Product Resets During Vehicle Start

The external FM modulator frequencies are FM 87.7, 87.9, 88.1, 88.3, 88.5, 88.7,
88.9, 106.7, 107.1 and 107.5.
Using the external wireless IR headset
A separately sold wireless IR headset is required for utilizing the IR transmitter
function.
A dual channel wireless IR headset has a two-position slide switch labeled “A/B”.
When the switch is in the “A” position, the headset plays audio from the source
designated as “IR A.” When the switch is in the “B” position, the headset plays
audio from the source designated as “IR B.”
Troubleshooting
If you have problems operating this product, please refer to this section. The most
common problems are listed below, along with likely causes and solutions.
- Car engine has not been started. Start the car engine.
- Incorrect wiring connection. Check the wiring.
- Fuse has been damaged. Replace fuse.
No power
- Volume is too low. Adjust volume.
- Incorrect wiring connection. Check the wiring.
No sound
- Video DVD settings do not match with the DVD. Adjust video DVD settings.
- Video connection is incorrect.
Image flashes or distorted
- Set the FM transmitter to an alternate radio station. Then tune the radio to the
newly selected station.
Audio static through the vehicle’s speakers
- Ensure the car battery is fully charged and in good condition.
- Avoid using the product without running the engine.
The product resets when I start my vehicle
14