Page: 8
Mounting and Connecting tips
Mounting
alternatives
wall. The wall behind and the wall beside the
loudspeaker have influence on both the bass level
and the bass characteristics, so please be patient
distances to the rear and side
Connect using the
correct phase
Always connect using the correct phase, from the
+-pole on the amplifier to the +-
loudspeaker and corresponding for minus (-).
If you by accident connect the other
there is no risk of damage. However, the
sound will not be correct, especially in the
lower frequencies.
Overload
At high load during extensive time periods, there is
always the risk of overloading the driver and
for high power, so be careful not to play
extremely loud and not to increase tre
or bass settings to much.
By increasing the bass or treble from 0 to
max you will increase the power by about
16 times.
The initial playing
time
t takes about 50 to 100 hour of initial playing time,
for the driver to sound optimal. During this time
the speaker may be used as normally.
Connect cables from the output of the cross over
box to the connections on the speaker.
It is important that this is done in a correct way.
If this is done wrong, the drivers can be destroyed.
The tweeter output on the cross over box should be
connected to the tweeter on the speaker.
The woofer output from the cross over box should
be connected to the woofer on the speaker.
ver that has been destroyed
Be careful when you connect the
Check what is input and output on
the cross over, before connecting.
To Next Page
Loading...
Need help?
General
