QUICK START
1. POWER AND CHANNEL
Turn the units on by pressing and holding the power
button for 3 seconds, until the display screen lights up.
Short presses on the power button will switch to the
next channel (check the 1-4 channel display). Make sure
you set the same channel on both the transmitter and
the receiver. When the units are successfully paired,
the green LED on the receiver will illuminate.
2. INSTALL THE FUR WINDSHIELD
The fur windshield is specially designed to reduce
wind noise when recording outdoors or in dicult
environmental conditions.
11
POWER ON / CHANNEL
POWER ON / CHANNEL
Transmitter
Receiver
To Next Page
Loading...
