3
To remove tube from “OUT” port:
1. Place slotted tube from “Outlet Port Fitting
Kit over 1/4” tube
2. Push slotted tube against fitting on unit
3. Pull1/4” tube out
Kitchen/Refrigerator
with single inlet BW System
Coffee Cart/Kiosk with single
inlet BW System
Typical Beverage Installations
Figure 2
Operation
The Bottled Water Dispensing System may also be
placed in a pantry, closet, cellar or other location
where a grounded electrical outlet is available.
• Fill water tank
• Connect suction wand universal cap to
the bottle
• Turn pump switch “ON”
• When water is free of air, turn all faucets
off beginning with the faucet closest to
the pump.
Important: Do not operate the pump
more than 20 minutes continuously.
Regular cleaning and sanitizing of the
Flojet Bottle Water System is required.
To Next Page
Loading...
