5
EXPLODED VIEW
shaft. Tighten the chopper while holding the motor shaft at the rear of the motor. Position a new O-ring in the seal housing O-ring groove (it
may be retained in the groove with a small amount of grease).
Slide the pump assembly into the toilet base ensuring the macerator housing is properly positioned within the base. The cut-out in the side
of the macerator housing must align with the discharge port in the base (the macerator housing is keyed so it will only go in when properly
positioned). Ensuring the O-ring is still properly positioned in the O-ring groove in the seal housing, place the pump assembly against the
base and secure it in place with the four screws and lock washers. Replace the white motor cover by snapping it down over the pump motor.
WARNING: FLOOD HAZARD
If toilet is plumbed to an overboard discharge, close the discharge seacock prior to disassembling toilet.
Failure to do so can result in flooding which can cause loss of property and life.
VUE ÉCLATÉE / EXPLODIERTE ANSICHT / VISTA ESPLOSA / UITGEBREIDE WEERGAVE / SPRÄNGVY / VISTA EXPLOTADA
Key KeyDescription DescriptionPart Number Part NumberQty. Qty.
1
2
3
5
7
8
9
10
11
13
15
12
14
16
17
18
19
20
21
22
23
24
25
28
29
* Parts Supplied with Service Kit
** Parts included with base 37004-1000
† Parts included in Motor & Pump Assembly
26
27
7A
7B
7C
7D
7E
7F
3 & 4
Seat & Cover
Note - 2016 models identified with Jabsco logo on top of bowl.
Compact
Compact (ALL VARIANT)
Regular (Pre 2018)
Regular (Pre 2018)
Regular (2018 onwards)
Regular (2018 onwards)
Hose, 6 feet
Bowl Installation Hardware
Bowl O-Ring Seal
Base Assembly**
1-1/2” Adapter, Discharge Port
Joker Valve* **
Screw**
Macerator Housing †
1” Discharge Port**
Chopper Plate with Lock Nut †
Centrifugal Impeller †
Set Screw †
O-ring* †
Seal* †
Screw †
Washer, Plastic* †
Seal Housing †
Lock Washer #10, Stainless Steel †
Screw †
Slinger †
Switch Panel
Screw Covers (3/kit)
Service Kit
Motors:
Solenoid Valve:
Motor & Pump Assembly
Nut Cap**
Motor - 12 Volt †
12 Volt
12 Volt
Motor - 24 Volt †
24 Volt
24 Volt
Hex Nut** (Two places)
Washer, Stainless Steel**
Washer, Plastic**
Washer, Starlock**
Phillips Head Screw**
Compact
Soft Close (2018 onwards)
Soft Close (2018 onwards)
Bowl Spud & Intake Elbow &
O-ring
Regular
Bowl
Hinge Set (1 PAIR)
29097-1000
29098-1000
29127-1000
29098-2000
58104-1000
58105-1000
29035-1031
18753-0637
44101-1000
37004-1000
98023-0080
44106-1000
96050-0568
37014-0000
44107-1000
37056-1000
37006-0000
43990-0066
1040-0000
35445-0000
37043-1000
91027-0011
6342-0000
37047-2000
90197-0000
18753-0554
37038-2012
37072-0092
18753-0555
37038-2024
37072-0094
29096-0000
58104-2000
58105-2000
58107-1000
29126-0000
1
1
1
1
1
1
1
1
1
1
1
1
3
1
1
1
1
1
1
1
2
2
1
4
4
1
1
1
4
1
1
1
1
1
1
8
4
4
4
4
1
1
1
1
1
To Next Page
Loading...
Need help?
General
