en - Original instructions
42
not take
place (the
set has nev-
er
to stop), a
“forced”
rotation of
the duty
pumps is
performed
time has
only in the
case of sys-
tems with
sensor.
Halves the
timing (t10,
in the case
variation of
the feed-
back (pres-
sure, levels,
tempera-
1= Enabled
REAL TIME CLOCK
AUTO-TEST RUN
With this function, the pumps are started once per
week and at a set time and day, or after a time of
inactivity.
(Refer to section 6.1 for description)
periodic
Auto-test
1= Weekly
2= Time of
inactivity
period of
pump 1
inactivity
period of
pump 2
ly auto-test
(c24=1)
3= Wednes-
day
4= Thursday
5= Friday
6= Saturday
hour of
weekly auto-
minutes of
weekly auto-
operating
time of the
the weekly
auto-test
(c24=1)
CHANGE SET POINT (only for system with ana-
logue sensor)
mode to
change the
set point
1= Internal
clock
2= From digi-
of the set
point. The
threshold of
each pump
(r08, r09, r
r11, r12, r13)
are in-
creased and
the value
scale
ous
start hour for
changing the
set point
start minutes
for changing
the set point
stop hour for
changing the
set point
stop minutes
for changing