EasyManua.ls Logo

Xylem McDonnell & Miller RB-24E User Manual

Xylem McDonnell & Miller RB-24E
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTRUCTION MANUAL
MM-228Q
Model RB-24E
Conductance Type
Low Water Cut-Off
For Residential 24 VAC Hot Water Boilers
Question and Answer IconNeed help?

Do you have a question about the Xylem McDonnell & Miller RB-24E and is the answer not in the manual?

Xylem McDonnell & Miller RB-24E Specifications

General IconGeneral
ModelRB-24E
Frequency50/60 Hz
BrandXylem McDonnell & Miller
Part NumberRB-24E
CategoryControl Unit
Switch TypeSPDT
Housing MaterialNEMA 1
ApprovalsUL, CSA
Voltage24V
Voltage Rating24V AC/DC
Operating Temperature Range32°F to 120°F (0°C to 49°C)

Summary

Product Introduction and Safety

General Safety Warnings

Key safety precautions for installation, operation, and potential hazards. Includes warnings about electrical shock and chemical exposure.

Operation and Specifications

Product Operation

Explains the function of the RB-24E in preventing burner cut-off during unsafe water loss.

Technical Specifications

Details operating ranges, pressure, temperature, electrical ratings, and enclosure type.

Important Usage Restrictions

Highlights critical applications where the RB-24E should not be used, such as steam boilers or millivolt systems.

Wiring Harness Adapters

Lists available adapters for different boiler system connections and their specific applications.

Installation Guide

Step 1: Determine Installation Location

Guidance on selecting the optimal placement for the probe control on the boiler or piping.

Typical Installation Diagrams

Illustrates recommended mounting positions for the low water cut-off on the boiler or in a pipe tee.

Probe Installation Requirements

Specifies critical clearance requirements for the probe from internal metal surfaces.

Electrical Wiring Options

Option 1: Simple Series Circuit Wiring

Detailed wiring instructions for boilers using a basic series circuit for operation.

Option 2: Aquastat Relay Wiring

Wiring guide for systems with an aquastat relay, connecting the RB-24E in series with the gas valve.

Advanced Wiring Configurations

Option 3: Relay Control Wiring

Wiring diagram for boilers utilizing relays to manage burner and circulator circuits.

Option 4: Specific LWCO Wiring

Instructions for wiring the RB-24E based on boiler diagrams indicating LWCO placement.

Installation and Testing Procedures

Step 3: Installing the Low Water Cut-Off

Step-by-step instructions for physically mounting the probe and tightening connections.

Step 4: Testing the Control

Procedure to verify the correct operation of the low water cut-off after installation.

Control Testing and Troubleshooting

Testing Control Using Test Button

How to use the test button to simulate a low water condition and verify safety shut-off.

Troubleshooting Common Issues

Diagnostic steps for common operational failures like failure to turn off or turn on.

Maintenance Schedule

Recommended intervals for testing, inspection, cleaning, and replacement of the low water cut-off.

Warranty Information

Commercial Warranty Details

Terms and conditions of the warranty for commercial buyer purchases.

Limited Consumer Warranty

Warranty coverage and limitations for personal, family, or household use.

Related product manuals