tip and screw back the knurled nut barrel assembly using only firm hand pressure to
tighten. Pliers should only be used to tighten the nut to avoid burning your fingers, but
care should be taken not to over-tighten as this would damage the element.
GENERAL CLEANING
The outer cover of the iron and station may be cleaned with a damp cloth using small
amounts of liquid detergent. Never submerse the unit in liquid or allow any liquid to
enter the case of the station. Never use any solvent to clean the case.
SERVICE
If the iron or station should become faulty or, for some reason not operate normally,
the system should be returned to the service department of your authorized dealer or
agent.
WARNING: Keep out of the reach of children.
WARNING: Do not inhale solder fumes.
WARNING: Keep tip and heating element away from the body and clothes while in
operation.
REPLACEMENT TIPS:
To Next Page
Loading...
Need help?
General
