Yaber U10 - Installation; Projector Installation Methods

ftersales@yabertech.com
Note:
1).Install 2 pieces of AAA batteries into the remote controller before using it.
Do not combine new batteries with old ones in remote controller, which can
cause operation failure due to insufficient power supply.
2)When using the remote controller, please make sure that the signal
transmitter of the remote controller aims at infrared signal receiver of the
projector.
3).If you are not using the remote controller for an extended period, please
take out batteries to prevent batteries leakage.
INSTALLATION
1. Installation Method
The projector can be hanged on the ceiling with special hanger frame, and
placed on the stable desk to project the image according to the operating
environment and requirements. In addition, the projector can be installed with
following methods:
Al Adj
1.Front projection Ceiling mount | 2.Rear projection Ceiling mount
e i AaA
3.Front projection Table mount 4 Rear projection Table mount
Keep the projector at a height where its lens is axial symmetry to the screen.
If this is not possible, use the keystone correction function to adjust the
projection image.
If you want to get a free projection screen,please contact us via
aftersales@yabertech.com
06