Yaber U5 - STARTING PROJECTOR; Turn on the projector; Turn off the projector

£ aftersales@yabertech.com
B.Use the M4 * 10mm screws to hang the projector on the stand.
STARTING PROJECTOR
Turn on the projector
1.Install two AAA batteries in the remote control before using.
2.Plug in the power cord, and the power light turns red.
3Press he Power key on the remoteor panel the ndicaor fight wil tum green@
S
4.Remove the lens cover of the projector, the lamp wil start working 2 seconds
later, when an image is projected on the screen the machine is working smoothly.
If the first projection screen is not the start up screen, press the "S" button on the
remote and select USB source.
5 Adjust the keystone ring to get a rectangle shape.
6.Adjust the focus ring or rotate the lens of the projector to get the best image
performance. (If it is still blurry, please try to adjust the projection distance.)
7.If you connect other devices, be sure to select the corresponding source. If you
do not select the correct source, the projector will not be able to detect the signal.
8.Press the Menu button on the remote control to enter the OSD Language to set
your preferred language;
Turn off the projector
1.Press the Power button when the projector is in use, this will cause it to switch
to standby mode.
2.When the projector switch into standby mode, the light will tumn green from red.
07