Yaber V10 - 4 D Keystone Correction; Projector Setup; Input Signal Source Selection

=4 Support@yabertech.com
a
@]-» O #l 9‘)3
Rotate the focus ring or lens slowly. At the same time, check the focus point
carefully. The best focus point for the lens would be where the image most
clear.
Note: Ifitis still blurry, please try to adjust the projection distance.
2.Digital 4D Keystone Correction.
Use the digital 4D keystone correction of the projector to change the image to
be rectangle(vertical and horizontal). Detail please refer the page 16 of this
manual.
SETTING UP THE PROJECTOR
The projector's home page is as follow.
00:07 >R o]
1.Select The Input Signal Source
Select the desired input signal source (HDMI1/HDMI2/AV) on the home-page
09