11
PAIRING
The Yada Backup Camera included is already paired with the monitor. If you can not see the Camera
image, pair the Camera with the following steps:
1. Turn on your vehicle and place in reverse gear. This will power the Monitor and the Camera.
2. On the monitor:
a. Press “Menu”
b. Go to “Pair Camera”
c. Press “Parking Aid line” to conrm
d. The unit is now in pair mode - if the monitor is able to connect with the camera, the
display will show “Pair OK”.
If no camera is found, then the display will show “Pair Fail”. If you receive a “Pair Fail” message,
please call our technical support to assist in troubleshooting.
To Next Page
Loading...