Check whether the amount of lubricating oil filled in each
part of the vehicle is sufficient, and whether each
operating handle and rotating shaft rotate flexibly. If not,
add an appropriate amount of No.20 oil to the rotating
shaft and friction flour, and drip with Oil can. When the
operating mechanism controlled by the steel cable is
inflexible, an appropriate amount of No.20 oil should be
added to both ends of the steel cable. However, it is strictly
prohibited to inject oil into the electrical switch and the
brake friction area.
37 38
Check the lubrication condition of various
parts of the vehicle
1.Turn off the the power supply of the whole vehicle
before cleaning, and it is forbidden to touch the point
parts such as battery charging and discharging ports
with wet metal conductors.
2.It is strictly prohibited for water to impact electrical
components. When cleaning the vehicle, the vehicle
shall be wiped with a wet towel after being thrown dry.
3.Avoid water flow impacting charging socket, wire
harness connector, safety tube, etc. Do not pour water
directly into the container.
4.Do not directly splash water on brakes, motors and
front and rear axles to prevent water from affecting
the service life of vehicle components.
5.Do not use steam or high pressure water pipes
for washing vehicles.
Water washing cautions
To Next Page
Loading...
Need help?
General
