Need help?Do you have a question about the Yaesu FT-2980E and is the answer not in the manual?
General| Frequency Range | 144-146 MHz |
|---|---|
| Modulation | FM |
| Channel Capacity | 200 |
| Dimensions | 160 x 55 x 185 mm |
| Weight | 1.9 kg |
| Memory Channels | 200 |
| Operating Modes | FM |
| Supply Voltage | 13.8 VDC ±15% |
| Antenna Impedance | 50 Ohms |
| Channel Steps | 5/10/12.5/15/20/25 kHz |
| Current Consumption | 15 A (max) |
| Sensitivity | 0.2 μV |
| Selectivity | 12 kHz |
| Audio Output | 3W |
Explains the manual's content and symbols used for important information.
Defines the symbols and their significance for warnings, cautions, and prohibited actions.
Lists the items included in the transceiver package with the product.
Covers preliminary inspection, installation tips, and general advice for setting up the transceiver.
Describes the procedure for powering the transceiver on and off using the PWR key.
Explains how to listen to weather broadcasts and the severe weather alert feature.
Details manual selection of repeater shifts and how to reverse transmit/receive frequencies.
Explains how to set up CTCSS for repeater access, including tone mode and frequency selection.
Explains how to manually generate DTMF tones during transmission for autopatch or repeater control.
Explains the procedure for storing frequencies, shifts, and tones into memory channels.
Explains how to start, stop, and manage basic scanning in VFO and Memory modes.
Explains how to select between SINGLE and CONTINUE modes for the Smart Search feature.
Details accessing the Internet Connection feature via the SRG mode for WIRES network links.
Explains how to set up and activate ARTS™ for signaling communication range with other equipped stations.
Describes activating and setting a four-digit password to prevent unauthorized use of the transceiver.
Details how to clear all memories and reset settings to factory defaults by microprocessor reset.
To Next Page
