Yale EF-KIT1 - 6 Expanding the System with Accessories; Adding Devices via Key Pad; Adding Devices via Key Fob

10
Adding accessories to an existing system
To provide additional protection you can add extra Door/Window Contacts, PIRs, Key Fobs,
Key Pads, Panic Buttons and Smoke Detectors. These are available separately from your
local stockist.
Using your existing Key Fob:
1. Press the Arm and Home buttons together
continuously for 5 seconds until the LED stops
flashing to switch off the tamper while installing
the new device.
(The Siren will beep in response.)
2. Press the Home and Emergency (+) buttons
together continuously for 5 seconds until the LED
stops flashing to enter learn mode.
(The Siren will beep and flash in response.)
3. Press device learn/test buttons on the new
devices (see Chapter 2 for button location) to
trigger learning-in signals.
Examples: To add a new Key Fob, you will need
to press the top button (Arm/Learn). To add a
new Key Pad, you will need to press button 8 & 9
together to transmit learning-in signals.
(The Siren will beep and flash when each device is learnt in.)
4. When all the devices have been learnt-in press
and hold the Disarm button to quit learn mode.
5. Press the Arm and Emergency (+) buttons
together continuously for 5 seconds until the LED
stops flashing to rearm tamper protection.
Adding devices to an already installed
system
The installed system will be controlled by either a
Key Fob(s) or a Key Pad(s).
Using your existing Key Pad:
1. Enter Setting mode: Press Panic Button A
followed by the PIN Code
(Indicated by a continuously flashing LED.)
2. Switch OFF system tamper: Press
Panic Button A followed by 2
(The Siren will beep in response.)
3. Enter learn mode: Press Panic Button A followed
by 4 . (The Siren will beep and flash in response.)
4. Learning: Press device learn/test buttons on the
new devices (see Chapter 2 for button location) to
trigger learning-in signals.
Examples: To add a new Key Fob, you will need
to press the top button (Arm/Learn). To add a
new Key Pad, you will need to press button 8 & 9
together to transmit learning-in signals.
(The Siren will beep and flash when each device is learnt in.)
5. Exit learn mode: When all the devices have been
learnt in, press Panic Button A and 5 to quit learn
mode.
6. Switch ON system tamper: Press Panic Button
A and 3 to rearm tamper protection.
7. Exit Setting mode: Press Disarm twice to exit.
(The Key Pad LED will now stop flashing.)
6
7
Please note that you cannot have more than
one siren in your system.