LIFT INTERRUPT
The lift interrupt feature stops lift operation when the
battery discharge indicator (BDI) reads empty to pro-
tect the battery from excessive discharge and possi-
ble damage.
VISIBLE/AUDIBLE MOTION ALARM
This parameter selects the motion alarm (back-up
horn and strobe) activation logic.
• 0 = No Alarm
• 1 = Reverse Travel
• 2 = Forward Travel
• 3 = Forward Travel OR Reverse Travel
• 4 = Lifting
• 5 = Reverse Travel OR Lifting
• 6 = Forward Travel OR Lifting
• 7 = Forward OR Reverse Travel OR Lifting
• 8 = Lowering
• 9 = Reverse Travel OR Lowering
• 10 = Forward Travel OR Lowering
• 11 = Forward OR Reverse Travel OR Lowering
• 12 = Lifting OR Lowering
• 13 = Reverse Travel OR Lowering OR Lifting
• 14 = Forward Travel OR Lifting OR Lowering
• 15 = Forward OR Reverse Travel OR Lift OR
Lowering
• 16 = Continuous Key On
TRAC EN. LIGHT
SPED option to have lights turn on when certain ac-
tions occur.
• 0 = No Light
• 1 = Reverse Travel
• 2 = Forward Travel
• 3 = Forward Travel OR Reverse Travel
• 4 = Lifting
• 5 = Reverse Travel OR Lifting
• 6 = Forward Travel OR Lifting
• 7 = Forward OR Reverse Travel OR Lifting
• 8 = Lowering
• 9 = Reverse Travel OR Lowering
• 10 = Forward Travel OR Lowering
• 11 = Forward OR Reverse Travel OR Lowering
• 12 = Lifting OR Lowering;
• 13 = Reverse Travel OR Lowering OR Lifting
• 14 = Forward Travel OR Lifting OR Lowering
• 15 = Forward OR Reverse Travel OR Lift OR
Lower
• 16 = Continuous Key On
TRAVEL SPEED REDUCTION
This parameter setting enables or disables the Travel
Speed Reduction feature. When this feature is activa-
ted and the forks are below 20", the max speed is
8 km/h (5 mph). If the forks are above 20" when this
feature is activated, the max speed is 2.4 km/
h (1.5 mph).
LIFT LIMIT OVERRIDE
Inhibits lifting when a certain fork height is reached,
and an operator command to override the limit and lift
beyond. Lifting is inhibited when the limit switch goes
open.
SERVICE REMINDER
This can be used by the service technician to display
the message "NEEDS SERVICE" on the dash display
when the truck is due for service. To use this feature,
set this function to the Hour Meter reading at which
the service is to occur. When that hourmeter is
reached, the Dash Display will show the message
"NEEDS SERVICE" and traction performance will be
reduced until the service is performed. After servicing,
adjust the service reminder parameter to the next de-
sired service time.
TRUCK INSPECTION
This function is used to enable the check list feature
(per operating manual). A setting of OFF will disable
the function and normal operation can take place. A
setting of ON will enable a check list to be displayed.
The checklist will appear upon each key ON there-
after. Operator must answer YES to all inspection in-
quiries for full truck operation to ensue.
Parameter Descriptions 2200 YRM 1415
10
To Next Page
Loading...
