To Next Page
W
wdennisSep 4, 2025
What to do if Automix cannot record on my Yamaha Music Mixer?
- JJennifer AustinSep 5, 2025
If Automix cannot record, make sure that the Automix function is enabled.
What to do if Automix cannot record on my Yamaha Music Mixer?
If Automix cannot record, make sure that the Automix function is enabled.
Why is there no sound from input signals on my Yamaha 03D stereo output?
If input signals are present but the stereo output is dead, raise the ST OUT fader and ensure the ST OUT [ON] button is activated. Also, verify that the channels are correctly routed to the stereo output.
What to do if my Yamaha Music Mixer 03D cannot be turned on?
First, ensure the power cord is securely connected to a suitable AC wall outlet. Next, check that the 03D POWER switch is in the ON position. If it still does not turn on, contact your Yamaha dealer.
What to do if input signals are present but the display meters show nothing on my Yamaha 03D Music Mixer?
If input signals are present yet the display meters remain inactive, verify that the Meter mode isn't set to GAIN REDUCTION. This mode displays the amount of gain reduction applied by the dynamics processors.
What to do if I cannot recall mix scenes using MIDI Program Change messages on my Yamaha 03D?
If you're unable to recall mix scenes using MIDI Program Change messages, first ensure that the 03D is configured to receive Program Change messages and that the MIDI Channels match. Also, check the mix scene to Program Change assign table.
How to fix low input channel signal level on Yamaha 03D Music Mixer?
If the input channel signal level is very low, make sure that the GAIN control and PAD switch (channels 1 to 8) are set correctly. You can also use the Meter pages to check the levels.
How to troubleshoot signals connected via DIGITAL ST IN or YGDAI sounding noisy on my Yamaha Music Mixer?
If signals connected via the DIGITAL ST IN or YGDAI sound noisy, make sure that the device sending these signals is synchronized to the master wordclock.
How to configure a stereo pair on my Yamaha 03D if the signal appears to be in mono?
If you've configured a stereo pair but the signal appears to be in mono, make sure that the odd channel is panned hard left, and the right channel is panned hard right.
What to do if solo mode is selected but nothing can be heard on my Yamaha 03D Music Mixer?
If solo mode is selected but you cannot hear anything, make sure that the MONITOR OUT SOLO/2TR IN switch is set to SOLO. Also, make sure that the MONITOR OUT control is turned up, and that on the Solo Setup page the SOLO TRIM control is turned up.
Why do channels seem to run out of headroom on my Yamaha 03D?
If channels seem to run out of headroom, especially when EQ boost is applied, use the Attenuator function on the EQ page to reduce the level.
General| Outputs | 8 |
|---|---|
| Sampling Rate | 44.1 kHz / 48 kHz |
| Bit Depth | 20-bit |
| Built-in Effects | Yes |
| EQ | 4-band parametric EQ per channel |
| MIDI | Yes |
| Control Surface | Yes |
| Type | Digital |
| Inputs | 16 |
| Effects Processors | 2 |
| Dynamic Processing | Compressor, Gate |
| Digital I/O | ADAT |
| Analog I/O | XLR/TRS combo |
| Power Supply | Internal |