3-16
3 Operation
2) Attach the engine shut-off cord to
your PFD. Install the cord clip onto
the engine shut-off switch by push-
ing the clip groove over the nut
beneath the knob. Be sure the cord
is not wrapped around the steering
wheel or tangled in the controls.
Engine Shut-off Switch
Clip with Cord
TIP: It is not possible to start the engine
with the clip removed from the engine
shut-off switch. However, the starter
motor will turn the engine over.
3) Put the control levers in the Neutral
position. The starter motor will not
operate unless the shift lever is
in Neutral. Turn the ignition key to
“Start.” When the engine starts,
release the key. If the engine does
not start after 5 seconds of crank-
ing, release the key. Wait at least 15
seconds before trying to start the
engine again.
BLOWER
WARNING
Gasoline vapers can explode
Operate blower for at least 4 minuutes and
check engine compartments bilge for
gasoline vapors before starting engines
Do not start engines if there is a fuel leak or
loose electrical connection
To Next Page
Loading...
