Yamaha 212X - Switches

2-14
2 FEATURES & FUNCTIONS
SWITCHES

Blower

Bilge Pump

Courtesy Light

Lights

Horn

No-Wake Mode
TIP: The helm switches will not work if
the battery switch in the battery com-
partment is turned to the off position.
See page 4-2 for more information.
Blower
Press this switch to turn on the blower
to ventilate the engine compartment.
See page 3-9 for more information.
Bilge Pump
Press this switch to activate the bilge
pump. See page 3-8.
Courtesy Light
This switch turns on the light

located
in the recess on the gunwale near the
helm.
Lights
This toggle switch controls the required
on-board lighting. Press the top of the
switch to turn on both the bow light
and stern light for night running. Press
the bottom of the switch to operate the
stern light alone when anchored at
night. Put the switch in the middle posi-
tion to turn off all lights (see page 3-9).
Horn
Pressing this switch activates the horn.
The horn can be used to signal other
boats as required by the “Rules of the
Road” (see page 1-14).
No Wake Mode
The No-Wake Mode System is use-
ful for operating the boat at a steady
speed with a minimal wake. This is
especially convenient when traveling
in harbors, channels, or other areas
posted with low speed limits as “no-
wake zones.”
No-Wake Mode can be engaged
when the throttles are at idle speed in
Forward, Neutral, or Reverse. Engine
speed will be set at 2400 rpm for con-
venient, no-wake maneuvering.
0
10
20
30
40
50
0
1
2
3
4
5
6
60
7
8
0
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
0
M
T
M
T
RPM
x1000
10
20
30
6
0
MPH
40
50
60
1
2
3
4
5
6
7
8
0
RPM
x1000
BILGE
NAV/ANC
HORN
COURT
LTS
BLOWER