Operation
38
EMU27565
Electric start models
WARNING
EWM01840
●
Failure to attached engine shut-off cord
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
●
Avoid accidentally pulling the cord dur-
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. Place the gear shift lever in neutral.
IP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3. Place the throttle grip in the “”
(start) position. After the engine starts,
return the throttle to the fully closed po-
sition.
4. Pull out / turn the choke knob fully. After
the engine starts, replace / return the
knob to the home position.
IP:
●
It is not necessary to use the choke when
starting a warm engine.
N
ZMU03714
ZMU03744
ZMU02959
ZMU04116
To Next Page
Loading...
