Operation
42
4. Open the throttle slightly without shifting
using the neutral throttle lever or free ac-
celerator. You may need to change the
throttle opening slightly depending on
engine temperature. After the engine
starts, return the throttle to the original
position.
IP:
●
On remote controls equipped with a neu-
tral throttle lever, a good starting point is to
lift the lever just until you feel resistance,
then lift slightly more.
●
The neutral throttle lever or free accelera-
tor can only be used when the remote con-
trol lever is in neutral.
5. Press in and hold the main switch to op-
erate the remote choke system. The re-
mote choke switch automatically returns
to its normal position when you release
your hand. Therefore keep the switch
pressed in.
IP:
●
It is not necessary to use the choke when
starting a warm engine.
●
Push in the main switch fully, or the remote
choke system will not operate.
6. Turn the main switch to “” (start),
and hold it for a maximum of 5 seconds.
7. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “” (on).
NOTICE:
Never turn
the main switch to “” (start)
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
OFF
ON
ZMU01880
N
ZMU02314
STARTOFF
ON
ZMU02315
STARTOFF
ON
ZMU03753
To Next Page
Loading...
