Why Yamaha 25BWC Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
How to fix Yamaha Outboard Motor trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha 25BWC Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
What to do if Yamaha Outboard Motor gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
What causes Yamaha Outboard Motor fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
How to fix Yamaha 25BWC tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
Why Yamaha 25BWC illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
What to do if Yamaha 25BWC fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
What does it mean when my Yamaha Outboard Motor gauge shows “----”?
General| Brand | Yamaha |
|---|---|
| Model | 25BWC |
| Category | Outboard Motor |
| Language | English |
Steps for safely removing the outboard motor from its shipping crate.
Procedures for correctly positioning and securing the outboard motor to the boat transom.
Overview of Yamaha propeller types designed to match outboard motor characteristics.
Guidance on choosing the most suitable propeller based on application and load.
Describes different remote control types (side mount, binnacle mount) and their applications.
Instructions for installing gauges, ensuring proper readability and clearance.
Functions and applications of the fuel management gauge, including kit contents.
Representative wiring diagrams for remote controls and instruments.
Lists engine models compatible with digital network gauges.
Steps for initial setup of digital network gauges and multi-sensor connection.
Common issues, causes, and solutions for gauge system problems.
Lists engine models compatible with Digital Network Premium Gauges (6Y9).
Wiring diagrams for dual station applications with 6Y9 gauges.
Overview of the multi-function tiller handle and its electrical functions.
Guidance on selecting the appropriate battery capacity and type for different engine models.
Instructions for battery wiring, including isolator-equipped models and twin engine setups.
To Next Page
