What to do if Yamaha 40VWHTO fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
Why Yamaha Outboard Motor gauge operates unstably?
If the gauge operates unstably, it could be because a resistor is not connected to the ending hubs. Connect the gray 6-pin cap to the ending multi-hubs.
How to fix Yamaha 40VWHTO trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
Why Yamaha 40VWHTO Outboard Motor Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
What to do if Yamaha Outboard Motor gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
What causes Yamaha Outboard Motor fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
How to fix Yamaha 40VWHTO tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
Why Yamaha 40VWHTO illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
What to do if the Yamaha 40VWHTO Outboard Motor gauge display does not wake up?
If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or, if necessary, replace the gauge itself.
General| Horsepower | 40 hp |
|---|---|
| Cylinders | 3 |
| Steering | Remote |
| Full Throttle RPM Range | 5000-5500 rpm |
| Starting System | Electric |
| Shaft Length | 20 inches |
Details the steps for uncrating the outboard motor from its steel frame.
Provides guidelines for correctly mounting the outboard motor onto the transom.
Details the 703 side mount mechanical remote control.
Details the DEC binnacle remote control without mechanical cables.
Describes the features of the 6X4 multi-function tiller handle.
Describes the function and applications of analog tachometers.
Describes the digital tachometer's features and applications.
Describes speedometer types, applications, and calibration.
Describes the functions and applications of the fuel management gauge.
Describes the coolant temperature meter's function and applications.
Describes the hour meter's function and applications.
Describes the voltage meter's function and applications.
Explains the initial setup for digital network gauges.
Provides solutions for common gauge issues.
Lists recommended battery specifications by model and unit.
To Next Page
