PERIODIC MAINTENANCE AND MINOR REPAIR
6-29
6
EC000103
CAUTION:
_
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
_
6. Turn the key to “ON” and turn on
the electrical circuit in question to
check if the device operates.
7. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
8. Install the storage compartment
cover.
9. Place the ignitor unit panel in the
original position and install the
quick fasteners.
NOTE:
_
To install a quick fastener, push its pin
back so that it will protrude from the
fastener head, then insert the fastener
and push the protruding pin in until it is
flush with the fastener head.
_
10. Install the rider seat.
EAU04187
Replacing the headlight bulb
This motorcycle is equipped with a
quartz bulb headlight. If the headlight
bulb burns out, replace it as follows.
1. Remove the headlight unit by re-
moving the screws.
2. Disconnect the headlight coupler,
and then remove the bulb cover.
1. Quick fastener
2. Pin
After removal
Before installation
1. Screw (× 2)
E_5pb.book Page 29 Friday, June 15, 2001 4:46 PM
To Next Page
Loading...
Need help?
General
