Yamaha DSP-1 User Manual

eg
| ROOM SIZE=1. 0
HALL 1
LIVENESS=5
HALL 1
INIT DLY=30ms
HALL 1
HPF=THRU
HALL 1
LPF="IkHz
3 Parameter value change
The displayed parameter value can be changed by
pressing the DEC and INC keys of the remote control
transmitter.
EX: “LIVENESS” of the “HALL 1” program
The valuable range of this parameter is 0 to 10. The
preset value is “5”. However, increasing the value
makes the sound more live (echoic), and decreasing
the value make it more dead (anechoic).
Repeat the 2 and 3 operation so that the desired
sound field or sound effect is obtained.
Note: Even when the parameter value is changed,
recalling the other program resumes the initial
setting of the parameter value. To keep the
parameter-changed program, refer to the
“Program Memory” described below.
E PROGRAM MEMORY
Up to 16 kinds of programs can be stored in the user
program area (NO. 1 to NO. 16.) |
In the same way as “Program Recalling”, make sound
field or sound effect as desired.
The desired level and balance of the effect sound can
also be stored in memory for each program. .
When the MEMORY key of the remote control
transmitter is pressed, the PROGRAM NO. display on
the display window blinks (for approx. 5 seconds.)
During blinking storing the setting is possibie.
For example, to store the ACOUSTIC mode Hall 1
program modified as desired into the No. 2 memory of
the user program area:
1) Press the MEMORY key.
2) The program No. to be stored blinks (for 5
seconds).
3) During blinking, press the program key of the
-storing number. :
4)
At
this,
the
display
“HALL
1
MRMORY
STORE"
momentarily, and the program display resumes.
Program memory is completed.
The stored program can be recalled in the USER
PROGRAM mode at any time
Note: When the program has been stored in the user
program area with the same number, storeing
the new program cancels the previously-stored
program.

Yamaha DSP-1 Specifications

General

Brand	Yamaha
Model	DSP-1
Category	Computer Hardware
Language	English