Yamaha Electone HC-2 - Page 7

FCC Information (USA)
While the following statements are provided to comply with FCC
Regulations in the United States, the corrective measures listed are
applicable worldwide.
The digital series of Yamaha Electones™ use frequencies that
appear in the radio frequency range, and if installed in the imme-
diate proximity of some types of audio or video devices within three
meters (approximately ten feet), interference may occur.
This series of Yamaha Electones™ has been type-tested and found
to comply with the specifications set for a class B computer in
accordance with those specifications listed in sub-part J, part 15 of
the FCC rules. These rules are designed to provide a reasonable
measure of protection against such interference. However, this
does not guarantee that interference will not occur.
If your Electone™ should be suspected of causing interference
with other electronic devices, verification can be made by turning
your Electone™ off and on. If the interference continues when your
Electone™ is off, the Electone™ is not the source of the inter-
ference. If your Electone™ does appear to be the source of the
interference, you should try to correct the situation by using one or
more of the following measures:
CANADA
THIS DIGITAL APPARATUS DOES NOT EXCEED THE “CLASS B”
LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARA-
TUS SET OUT IN THE RADIO INTERFERENCE REGULATION OF
THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
This applies only to products distributed by Yamaha Canada Music Ltd.
LE PRESENT APPAREIL NUMERIQUE N’EMET PAS DE BRUITS
RADIOELECTRIQUES DEPASSANT LES LIMITES APPLICABLES
AUX APPAREILS NUMERIQUES DE LA “CLASSE B” PRESCRITES
DANS LE REGLEMENT SUR LE BROUILLAGE RADIOELECTRIQUE
EDICTE PAR LE MINISTERE DES COMMUNICATIONS DU CANADA.
Ceci ne s'applique qu’aux produits distribués par Yamaha Canada Music Ltd.
"Wichtiger Hinweis für die Benutzung in der Bundesrepublik Deutschland
Bescheinigung des Importeurs =
Hiermit wird bescheinigt daß der/die/das Elektronische Orgel Typ:
HC-2 HC-4 in Übereinstimmung mit den Bestimmungen der
VERFÜGUNG 1046/84.
(Amtsblattverfügng) funk- entstört ist. !
Der Deutschen Bundespost wurde das Berechtigung zur Überprü-
fung der Serie auf Einhaltung der Bestimmungen eingeráunt. !
Das Funkschutzzeichen ist beim VDE beantragt. |
Yamaha Europa GmbH: (Name des Importeurs)
- su CECI MAT M UE usss RER |
“Dies bezicht sich nur auf die von der YAMAHA EUROPE GmbH vertriebenen. Produkte,
Office, Washington DC. 20402.
"This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. —
Relocate either the Electone™ or the electronic device that is
being affected by the interference.
e Utilize power outlets for the Electone™ and the device being
affected that are on different branch (circuit breaker or fuse)
circuits, or install AC line filters.
e In the case of radio-TV interference, relocate the antenna or if the
antenna lead-in is 300 ohm ribbon lead, change the lead-in to
coaxial type cable.
If these corrective measures do not produce satisfactory results,
please contact an authorized Yamaha Electone™ dealer for sugges-
tions and/or corrective measures. If you can not locate an authorized
Yamaha Electone™ dealer in your general area, please contact the
Electone™ Service Department, YAMAHA CORPORATION OF
AMERICA, U.S.A., 6600 Orangethorpe Ave., Buena Park, CA 90620.
if for any reason, you should need additional information relating to
radio or TV interference, you may find a booklet prepared by the
Federal Communications Commission Helpful: “How to Identify
and Resolve Radio-TV Interference Problems.” This booklet, Stock
#004-000-00345-4, is available from the US. Government Printing