Yamaha F40 - Page 108

Trouble Recovery
102
If the water separator-alert indicator blinks,
perform the following procedure.
1. Stop the engine.
2. Remove the top cowling.
3. Remove the holder.
4. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
[ECM01951]
5. Unscrew the filter cup from the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when unscrewing the filter cup.
[ECM01961]
6. Drain the water in the filter cup by soak-
ing it up with a rag.
7. Firmly screw the filter cup onto the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when screwing the filter cup onto the
filter housing.
[ECM01971]
8. Connect the water detection switch cou-
pler securely until a click is heard.
1. Water separator-alert indicator
1. Holder
1
ZMU05441
1
ZMU06424
1. Water detection switch coupler
1. Filter cup
2. Water detection switch lead
1
ZMU06425
ZMU06426
1
2
6BG-9-3F-E0.book 102 ページ ２０１８年１１月１日 木曜日 午後５時１分
©2020 Yamaha Motor Corporation