Yamaha F40 - Operation; First-Time Operation and Break-In

Instruments and indicators
42
Lock mode
Make sure that the Yamaha Security System
indicator is off before starting the engine.
Water separator-alert indicator
If water has accumulated in the water sepa-
rator (fuel filter) while cruising, the water sep-
arator-alert indicator will start to blink.
Stop the engine immediately and see page
100 of this manual to drain the water from the
fuel filter. Get back to the port soon and con-
sult a Yamaha dealer immediately.
NOTICE
ECM00911
Gasoline mixed with water could cause
damage to the engine.
Engine trouble-alert indicator
If the engine malfunctions while cruising, the
engine trouble-alert indicator will start to
blink. Get back to the port soon and consult
a Yamaha dealer immediately.
NOTICE
ECM00921
In such an event, the engine will not oper-
ate properly. Consult a Yamaha dealer im-
mediately.
Low battery voltage alert
If the battery voltage drops, the battery volt-
age value will start to blink.
Get back to the port soon if the low battery
voltage alert device has activated. For charg-
ing the battery, consult your Yamaha dealer.
Overheat-alert indicator
If the engine temperature rises too high while
cruising, the overheat-alert indicator will start
1. Yamaha Security System indicator (optional)
1. Water separator-alert indicator
SET MODE
1
ZMU08412
1
ZMU08413
1. Engine trouble-alert indicator
1. Battery voltage value
1
ZMU08414
1
ZMU08415
6BG-9-3F-E0.book 42 ページ ２０１８年１１月１日 木曜日 午後５時１分
©2020 Yamaha Motor Corporation