What to do if Yamaha F40A Outboard Motor fuel management gauge shows incorrect fuel consumption?
If the fuel management gauge shows incorrect fuel consumption, the engine recognition might be wrong (especially for multi-applications). To fix this, default the engine number and turn the key switch on in order from the portside engine to re-memorize each engine number.
How to fix a Yamaha F40A Outboard Motor when the starter will not operate?
If the starter on your Yamaha Outboard Motor won't operate, here are some things to check: * The battery capacity might be weak or low – check the battery condition and use a battery of the recommended capacity. * Battery connections could be loose or corroded – tighten the battery cables and clean the battery terminals. * The fuse for the electric start circuit might be blown – check for the cause of the electric overload and repair it, then replace the fuse with one of the correct amperage. * Make sure the engine stop switch lanyard is attached and the shift lever is in neutral. If these steps don't resolve the issue, the starter components may be faulty, requiring service by a Yamaha dealer.
How to fix a Yamaha Outboard Motor when the starter won't operate?
If your Yamaha Outboard Motor's starter won't operate, here's what to check: * Ensure the engine stop switch lanyard is attached. * Make sure the shift lever is in neutral. * Check the battery condition; a weak or low battery can be the culprit. Use a battery with the recommended capacity. * Inspect battery connections for looseness or corrosion; tighten cables and clean terminals if needed. * Examine the fuse for the electric start circuit; if blown, check for the cause of the overload, repair, and replace the fuse with the correct amperage. * If none of these steps work, the starter components may be faulty, and you should have it serviced by a Yamaha dealer.
What to do if the Yamaha F40A Outboard Motor gauge display does not wake up?
If the gauge display doesn't wake up, it could be due to a lack of electrical power or a damaged gauge. Try these steps: replace the fuse, securely connect the couplers, replace any damaged wires or hubs, or, if necessary, replace the gauge itself.
Why Yamaha F40A illumination does not light?
If the illumination does not light, it could be due to a lack of electrical power or a damaged gauge. You should try replacing the fuse, connecting the couplers securely, replacing the damaged wire or hub, or replacing the gauge.
How to fix Yamaha F40A Outboard Motor tachometer showing incorrect engine RPM?
If the tachometer shows an incorrect engine RPM, the engine recognition might be wrong (especially for multi-applications). To correct this, push the 'SET' button for 10 seconds to default the engine number, then memorize each engine number again.
What causes Yamaha F40A Outboard Motor fuel management gauge to show incorrect remaining fuel?
If the fuel management gauge shows incorrect remaining fuel, the fuel capacity setting may be wrong (specifically for SQR Fuel mgt Gauge). Fill the tank with fuel, and set the correct fuel tank capacity.
What to do if Yamaha F40A Outboard Motor gauge shows “----”?
If the gauge displays '----', it indicates that the digital signal is not being received. Check that the couplers are securely connected and replace any damaged bus wires or hubs.
Why Yamaha Outboard Motor Speedometer or Comb. Speedometer & Fuel mgt gauge shows incorrect fuel level?
If the speedometer or combination speedometer & fuel management gauge shows an incorrect fuel level, the fuel sensor selection is likely wrong. Set up the fuel sensor to the correct resistance.
How to fix Yamaha F40A Outboard Motor trim gauge showing incorrect position?
If the trim gauge shows an incorrect position, the initial position setting might be wrong, or the trim sender could be damaged. Put the motor in the fully trimmed-in position and reset the initial (zero) trim angle. If that doesn't work, replace the trim sender.
General| Brand | Yamaha |
|---|---|
| Model | F40A |
| Category | Outboard Motor |
| Language | English |
To Next Page
