Yamaha F8 - Procedure for tilting down (manual tilt models); Procedure for tilting down

Operation
43
5. Models equipped with trim rods: Once the
outboard motor is supported with the tilt
support lever, press the power trim and
tilt switch / power tilt switch “” (down) to
retract the trim rods.
CAUTION:
ECM00250
Be sure to retract the trim rods completely
during mooring. This protects the rods
from marine growth and corrosion which
could damage the power trim and tilt
mechanism.
EMU30192
Procedure for tilting down (manual tilt
models)
1. Place the tilt lock lever in the lock posi-
tion.
2. Slightly tilt the engine up until the tilt sup-
port bar is automatically released.
3. Slowly tilt the engine down.
EMU28054
Procedure for tilting down
Power trim and tilt models / power tilt models
1. Push the power trim and tilt switch / pow-
er tilt switch “” (up) until the outboard
motor is supported by the tilt rod and the
tilt support lever / tilt support knob be-
comes free.
2. Release the tilt support lever or pull out
the tilt support knob.
3. Push the power trim and tilt switch / pow-
er tilt switch “” (down) to lower the out-
board motor to the desired position.
DN
ZMU01936
UP
DN
U60R13E0.book Page 43 Thursday, April 6, 2006 10:29 AM