Operation
40
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3. Place the throttle grip in the “ ”
(start) position.
4. Pull the manual starter handle slowly until
you feel resistance. Then give a strong
pull straight out to crank and start the en-
gine.
● If the engine does not start, place the throt-
tle grip in the “ ” (warm engine)
position and try again.
● It is not necessary to use the choke when
starting a warm engine.
5. After the engine starts, slowly return the
manual starter handle to its original posi-
tion before releasing it.
6. Slowly return the throttle grip to the fully
closed position.
U6DR70E0.book Page 40 Thursday, December 6, 2012 9:14 AM
To Next Page
