Yamaha FJR1300 User Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-8
6
Before installing a spark plug, the spark
plug gap should be measured with a
wire thickness gauge and, if necessary,
adjusted to specification.
Clean the surface of the spark plug
gasket and its mating surface, and then
wipe off any grime from the spark plug
threads.
NOTE:
_
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4–1/2 turn
past finger tight. However, the spark
plug should be tightened to the speci-
fied torque as soon as possible.
_
Specified spark plug:
CR8E (NGK) or
U24ESR-N (DENSO)
a. Spark plug gap
Spark plug gap:
0.7–0.8 mm
Tightening torque:
Spark plug:
12.5 Nm (1.25 m·kgf)
U5JWE2.book Page 8 Wednesday, November 6, 2002 3:32 PM

Yamaha FJR1300 Specifications

General

Displacement	1298cc
Compression Ratio	10.8:1
Final Drive	Shaft
Wheelbase	60.8 in
Fuel Capacity	6.6 gal
Bore x Stroke	79.0mm x 66.2mm
Fuel System	Fuel Injection
Ignition	TCI
Rear Suspension	Single shock, 4.9-in travel
Front Brakes	Dual 320mm discs
Rear Brakes	282mm disc
Front Tire	120/70ZR17
Rear Tire	180/55ZR17
Seat Height	31.7 in or 32.5 in
Curb Weight	642 lb