EasyManua.ls Logo

Yamaha FX High Output WaveRunner 2005 - Page 78

Yamaha FX High Output WaveRunner 2005
139 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-21
E
3. Attach the clip 1 to the engine shut-off
switch 2 and attach the engine shut-off
cord 3 to your left wrist.
WARNING
@
Check that the engine shut-off cord is not
frayed or broken, and keep it free from
the handlebars so the engine stops if the
operator falls off. The engine shut-off
cord may not pull free if wrapped around
the handlebars when the operator falls
off, allowing the watercraft to continue to
run and cause an accident.
@
N
O
TE:
@
It is not possible to start the engine with the
clip removed from the engine shut-off
switch.
@
4. Push the start switch (green button).
N
O
TE:
@
The engine will not start if the throttle lever is
squeezed.
@
5. Release the start switch as soon as the
engine starts to run.
CAUTION:
@
Never push the start switch while the
engine is running.
Do not operate the start switch for
more than 5 seconds, otherwise the
battery will be discharged and the
engine will not start. Also, the starter
motor may be damaged. If the engine
does not start in 5 seconds, release
the start switch, wait 15 seconds, and
then try again.
@
UF1S11.book Page 21 Monday, August 2, 2004 3:06 PM

Table of Contents

Related product manuals