21
3 PITCH BEND settings
Use the “LOWER” knob to set the lowest point in the pitch bend wheel’s range and the
“UPPER” knob to set the highest point.
4 PORTAMENTO block
Use the switch to enable/disable portamento and the “TIME” knob to specify the portamento
time. Click on the text box and select the portamento mode.
The “PORTAMENTO” block is not available for Drum Voices.
5 ARPEGGIO block
Use the switch to enable/disable the arpeggiator and the “TEMPO” knob to specify the
arpeggiator speed. Click on the text box below the switch to select the arpeggiator mode.
Click on the text box to the left of the switch to select the arpeggio type. The specific
parameters for the arpeggiator can be found in the “ARPEGGIO” dialog, opened by clicking the
[DETAIL] button.
6 [CTRL SET/COM LFO] button
Click this to open the “CONTROLLER SET /COMMON LFO” dialog. In the top panel, you can
specify the parameters for all controllers such as the pitch bend and modulation wheels. The
bottom panel lets you specify the parameters for the Common LFO.
The “COMMON LFO” panel is available only for Normal Voices.
“CONTROLLER SET/COMMON LFO” Dialog
CONTROLLER SET Panel
You can assign your synthesizer’s controllers such as the modulation wheel or keyboard aftertouch
to various parameters to allow them to be modified in real-time. For instance, you could assign the
modulation wheel to the filter’s Resonance parameter when the Normal Voice is selected. In all, up
to six controllers can be assigned.
1234
5
6
7
8
9
0
AB
C
DE
F
G
H
C
G
G
C
To Next Page
Loading...
Need help?
General
