Need help?Do you have a question about the Yamaha Moto matrix YZF-R6S and is the answer not in the manual?
General| Manufacturer | Yamaha |
|---|---|
| Model | YZF-R6S |
| Year | 2006-2009 |
| Category | Sportbike |
| Displacement | 599cc |
| Fuel System | Fuel Injection |
| Transmission | 6-speed |
| Final Drive | Chain |
| Front Tire | 120/70-ZR17 |
| Rear Tire | 180/55-ZR17 |
| Ignition | TCI (Transistor Controlled Ignition) |
| Front Brake | Dual hydraulic disc, 298 mm |
| Rear Brake | 220mm disc w/ single-piston caliper |
| Wheelbase | 1, 380 mm (54.3 in) |
| Length | 80.3 in |
| Fuel Capacity | 17.5 L (4.6 US gal) |
Step-by-step instructions for removing clutch components, including bolt loosening and special tool usage.
Procedure for inspecting friction plates for damage or wear, requiring replacement as a set.
Specifies fastener type (Bolt), size (M20), quantity (1), and torque values in Nm, m.kg, and ft-lb.
Checklist for diagnosing no spark or intermittent spark, including fuses, battery, and spark plugs.
Procedure to check battery condition and minimum open-circuit voltage for ignition system troubleshooting.
Instructions for checking spark plug condition, type, and gap for ignition system issues.
Method for measuring ignition spark gap using an ignition checker and testing for spark.
Procedure to measure crankshaft position sensor resistance using a pocket tester.
Checks for continuity of the clutch switch and starting circuit cut-off relay.
Check the entire ignition system's wiring for proper connection and defects using the circuit diagram.
Procedure to measure primary and secondary coil resistance using a pocket tester.
Checks for continuity of the main switch and engine stop switch for ignition system issues.
Procedure to measure the voltage of the lean angle cut-off switch under different tilt angles.
Procedures to check continuity of the neutral switch and sidestand switch.
Procedure to check headlight bulb and socket continuity and replace if faulty.
Measures voltage at the headlight coupler for low beam and high beam indicators.
Procedure to check meter light continuity and voltage, and replace assembly if faulty.
Procedure to check license light bulb/socket continuity and voltage, and replace if faulty.
Checks tail/brake light continuity and voltage, and replaces assembly if faulty.
Presents the complete wiring diagram for the YZF-R6S/YZF-R6SC models.
To Next Page
