Yamaha MT-10SP - Page 87

Periodic maintenance and adjustment
8-12
1
2
3
4
5
6
7
8
9
10
11
12
13
5. Remove the oil filter cartridge with
an oil filter wrench.
TIP
An oil filter wrench is available at a
Yamaha dealer.
6. Apply a thin coat of clean engine
oil to the O-ring of the new oil filter
cartridge.
TIP
Make sure that the O-ring is properly
seated.
7. Install a new oil filter cartridge, and
then tighten to the specified
torque.
8. Install the cowling in its original po-
sition, and then install the bolts.
1. Bolt
2. Cowling
1. Oil filter cartridge
2. Oil filter wrench
1
1
1
2
1 11
2
1. O-ring
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 13 lb·ft)
1. Bolt
2. Cowling
1
1
1
1
2
BGG-28199-11.book 12 ページ ２０２２年８月２５日 木曜日 午後３時８分